The shadow server tries to resize the client to use a compatible
resolution. If that fails, e.g. if there is another resize request after
the disconnect/reconnect sequence, abort the connection.
* Use new ConvertUtf8ToWChar, ConvertUtf8NToWChar,
ConvertUtf8ToWCharAlloc and ConvertUtf8NToWCharAlloc
* Use new ConvertWCharToUtf8, ConvertWCharNToUtf8,
ConvertWCharToUtf8Alloc and ConvertWCharNToUtf8Alloc
* Use new Stream UTF16 to/from UTF8 read/write functions
* Use new settings UTF16 to/from UTF8 read/write functions
* Fixed format strings to match arguments
Reviewed and replaced all %d specifiers to match proper type
* Added proxy dynamic channel command type to log messages.
The shadow server was setting up the dynamic channel too quickly, leading
to unexpected packets during the negotiation (unexpected licence packet error
message on the client side). So let's starts dynamic channel once the activation is
done.
* Use freerdp_settings_* for shadow and sample server
* Added freerdp_peer_set_local_and_hostname
* Code cleanups and WINPR_ASSERT
* Code cleanups
* Use CHANNEL_NAME_LEN where appropriate
* Use temporary variables in loop instead of direct array access
* Monitor coordinates are exclusive
* Remove force override of shadow resolution.
The client might ignore the server requested values, in that case
retry
* shadow_server: allow specifying IP addresses to listen on
This allows using IPv6 as well as listening only on specific
interfaces. Additionally, it enables listening on local and TCP
sockets simultaneously.
* listener: log address with square brackets
This disambiguates IPv6 addresses.
* shadow_server: check error on each socket binding
* Refactored shadow /bind-address for 2.0 compiatibility.
* Made /ipc-socket and /bind-address incompatible arguments.
* Fixed shadow /bind-address handling and description
* Allow multiple bind addresses for shadow server.
Co-authored-by: akallabeth <akallabeth@posteo.net>
* Pass on proper command type to application
* On send let the server implementation decide to send
2.2.9.2.1 Set Surface Bits Command (TS_SURFCMD_SET_SURF_BITS) or
2.2.9.2.2 Stream Surface Bits Command (TS_SURFCMD_STREAM_SURF_BITS)
Thanks to @viniciusjarina for tracing the issue down.
